5050 single color 60 lamp set 5 meters 3A Power Supply

Precautions for installation of LED Light Strips

1. Do not turn on the power to light up the LED strip without the entire roll of light strips being separated from the packaging or piled up in a ball Lamp Beads 5050.

2. When the light strip needs to be cut according to the length of the site installation, the light strip can only be cut at the place where the scissors mark is printed, otherwise one of the units will not light up. Generally, the length of each unit is 1.5-2 meters.

3. When connecting the power supply or connecting two pieces of light strips in series, first bend the head of the colorful light to left and right, so that the wires in the light strip are exposed about 2-3mm, cut it clean with pliers without leaving burrs, and then use the male pin. To avoid short circuits Lamp Bead Patch.

4. Only LED strips with the same specifications and voltages can be connected in series, and the total length of the series connection cannot exceed the maximum allowable length.

5. When the light strips are connected in series, each segment is connected, that is, one segment of the pilot is lit, so as to find out whether the positive and negative poles are connected wrongly and whether the light emission direction of each segment of the light strip is consistent.

6. The end of the light strip must be covered with a PVC tail plug. After tightening it with a clamp, seal the circumference of the interface with neutral glass glue to ensure safety SMD LED Lamp Beads.

7. Due to the unidirectional conductivity of LEDs, if you use a power cord with an AC/DC converter, you should perform a power-on test after completing the power connection to make sure that the positive and negative poles are connected correctly before putting it into use.

Box gauge
50 sets/box
50*45*35